Washer won't drain, won't spin, leaks onto the floor or smells musty? Our local technicians fix front-load and top-load washers in laundry rooms across Leander.
These are the washer problems we hear about most. Open a question to see the usual causes and what you can safely check before you call.
Front-load washers seal tight, and the rubber boot around the door holds water in its folds. Mold and mildew grow there and give the whole load a musty smell.
Lint, hair and small items collect in the drain pump filter. Water that sits behind the clog turns stale and the smell spreads into every wash.
Too much detergent or softener leaves a sticky film in the drawer and its channels. It grows bacteria and drips into the drum.
Quick check: Leave the door and the detergent drawer open between washes so they dry out, wipe the folds of the door boot, and run an empty hot cleaning cycle.
In belt-driven washers the belt turns the drum. When it stretches or breaks, the motor runs but the drum barely moves.
In many top-load washers a small plastic coupler links the motor to the transmission. It is built to break under strain, and once it does the drum stops spinning.
The board tells the motor when and how fast to turn. If it fails, the washer may fill and drain but never move into the spin.
Quick check: Open the washer and spread the load evenly, since one heavy item can stop the spin. If water is still standing in the drum, the problem may be the drain rather than the spin.
The valve opens to let hot and cold water in. If its coil fails, the washer hums or waits but no water comes through.
Small screens where the hoses connect catch sediment. Hard water in Central Texas leaves mineral buildup that can block them over time.
This switch tells the washer how much water is in the tub. A faulty switch can tell it the tub is already full, so it never starts filling.
Quick check: Check that both water faucets behind the washer are fully open and that the hoses are not kinked or squeezed against the wall.
The washer will not run unless the lock confirms the door is closed. A worn lock or latch can lose that signal and pause the cycle.
If the switch sends wrong water level readings, the washer can stop and wait for a fill or drain that never finishes.
The board runs every step of the cycle. A failing board can freeze in the middle, show an error code or restart the cycle on its own.
Quick check: Make sure the door closes firmly and nothing is caught in it. Unplugging the washer for one minute and plugging it back in can clear a temporary glitch.
When the laundry starts piling up, you want someone close by who picks up the phone. That is how we work.
Our 8 certified, insured technicians work around Leander every day. When you call, you reach the team that does the repair, not a dispatcher in another state.
We open the washer, find what failed and explain the repair before any work starts. If you go ahead with the repair, the service call and diagnosis cost you nothing.
Every washer repair comes with a 3-month warranty on the work. Need a visit before work or after dinner? We book seven days a week, 7am to 11pm.
We repair washers from these manufacturers, from simple top-loaders to stacked front-load units. Have a different make? Call and tell us the model.
Brand names and logos belong to their owners. We are an independent repair company and are not affiliated with or authorized by these manufacturers.
Tell us the brand, what the washer is doing and whether water is still in the drum. We'll call you back to set up a visit in Leander or nearby.
Request a repair
Leave your details and we'll call you back to confirm the time of the washer repair visit.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Your request is in. We'll call you shortly to set up the visit.
We come to your laundry room in Leander and the towns around it in Williamson and Travis counties.
Not sure if we reach your street? Give us a call and we'll tell you right away.
(111) 111-1111